User Manual

Scene memory
V5 Reference Manual
102
7 OFFSET knob
You can use the [TOUCH AND TURN] knob to set the time duration from scene recall
until the start of audio file playback. The offset value can be adjusted in the range of 0.0
– 99.0 in 0.5 sec steps.
8 Scroll knob
Use the [TOUCH AND TURN] knob to scroll the list.
Using Preview mode
Preview mode lets you view or edit the settings of a scene stored in memory without affecting
the signal processing of the current scene. When you recall a scene in this mode, the settings
of the newly recalled scene will appear on the panel of the QL series console, but the signal
processing of the current scene will remain as it was prior to the recall. Even if you modify the
settings and save them as a new scene or by overwriting, the signal processing of the current
scene will remain as it was prior to the recall. During an actual performance, it can be
convenient to use this to check the content of the scene you intend to recall next, or to make
minor changes to a scene and then store it.
NOTE
• PREVIEW mode applies to all parameters included in scene memory, all parameters included in
the INPUT PATCH and OUTPUT PATCH functions, and HA parameters.
• RECALL SAFE and FOCUS RECALL are enabled in PREVIEW mode.
Functions in Preview mode
The current scene will be modified by the following software and external operations.
• QL Editor
• StageMix
•MIDI Rx
• GPI IN
Similarly, edits for the current scene will be conveyed to the following software and external
devices.
• QL Editor
• StageMix
•MIDI Tx
•GPI OUT
The meters will indicate the state of signal processing for the current scene.
Playback Link will operate for recalling the current scene.
If cascade-connected, both master and slave units will operate independently. Link will not
occur while in Preview mode.
The following functions will not operate in Preview mode.
• Synchronization with QL Editor
• Switching users
• Changing the User Level
• Load/Save functions
• Cue changes
• USER DEFINED KEYS operations
• USER DEFINED KNOBS operations
• Monitor (MONITOR, CUE, OSCILLATOR, TALKBACK) changes or display
• Changing or viewing Nuendo Live settings
• Changing or viewing the recorder
• Changing DANTE SETUP or DANTE PATCH settings
• FADE TIME
• EFFECT FREEZE playback or recording
• MIDI clock and tap tempo for effects
• Internal metering for Premium Effects (GR for DynamicEQ and Portico 5043; VU for Opt-
2A, U76 and Buss Comp 369)
In addition, you cannot enter Preview mode while performing the following operations.
• While pasting scene or EQ settings
• While executing Global Paste
• While synchronizing with QL Editor
• While saving/loading a file
NOTE
The scene titles shown in StageMix will be changed to the titles used when using the store
operation on a QL series console operated in PREVIEW mode.
STEP
1. Press the PREVIEW button in the SCENE LIST window.
2. Use the [TOUCH AND TURN] knob to operate the SCENE SELECT knobs in the SCENE
LIST window, and select the scene number that you want to recall.
3. Press the RECALL SCENE button in the SCENE LIST window. To execute the Recall
operation, press the OK button.
4. If desired, use the panel controls to edit the settings.
5. If you want to store the changes you made in step 4, select the scene number in
which you want to store the scene, and press the SCENE MEMORY [STORE] key in
the SCENE LIST window.
6. When you have finished viewing or editing the settings of the scene, press the
PREVIEW button in the SCENE LIST window.