User Manual

Setup

V5 Reference Manual

244

 NEXT IP SETTING field

IP SETTING MODE select buttons

Use these buttons to select how to set the IP address the next time the console is turned

on. Select DHCP, AUTO IP, or STATIC IP.

NOTE

If you select AUTO IP, the Dante network automatically sets the console’s IP address to

169.254.xxx.xxx.

If you select DHCP or AUTO IP, the window will appear as shown below and you will be

unable to set the IP ADDRESS, SUBNET MASK, and GATEWAY ADDRESS.

3 IP ADDRESS

Specifies an address that identifies an individual device on the Internet or LAN network.

4 SUBNET MASK

Within the IP address used in the network, this defines the bits that are used for the

network address that distinguishes the network.

5 GATEWAY ADDRESS

Specifies an address that identifies a device (gateway) that converts data between

different media or protocols to allow communication within the network.

6 APPLY button

Press this button after you have changed the IP address settings. When the ATTENTION

window appears, press the OK button and then turn the console off and back on again.

7 Tabs

Use these tabs to select a group of items to view (FOR MIXER CONTROL or FOR DEVICE

CONTROL).

Setting up the Dante audio network

You will use the QL series console to make Dante audio network settings for the console itself

and the I/O devices connected to the Dante connector of the QL series console. This section

explains how to make Dante audio network settings.

STEP

1. In the Function Access Area, press the SETUP button to access the SETUP screen.

2. In the DANTE field at the center of the screen, press the DANTE SETUP button to

open the DANTE SETUP window.

3. Press the SETUP tab in the lower part of the DANTE SETUP window.

SETUP screen DANTE SETUP window