User Manual

ManualsBrandsYamaha ManualsAudio MixerQL Series

251

252

253

254

255

256

257

258

259

260

Setup

V5 Reference Manual

252

NOTE

QL console can recognize up to 24 Shure AXT400, QLXD4, and ULXD4 devices on the same

Dante audio network, including Shure ULXD4D and ULXD4Q Dante output devices that are set

to YAMAHA ID mode. Note that if a greater number of devices is connected, some of the devices

will not be recognized by the console based on the order in which their power is turned on, etc,

regardless of the mount setting.

1 CLEAR ALL button

Clears all I/O devices in the list to an unmounted state.

2 REFRESH button

Updates the displayed list of I/O devices on the Dante audio network.

3 I/O device select buttons

Press one of the buttons to open the DEVICE SELECT window. The upper line of the

button shows the device label. The lower line of the button shows the model name and

the number of inputs and outputs. If no device has been mounted, the upper row will

indicate “---” and the lower row will show nothing.

For more information on VIRTUAL/CONFLICT/DUPLICATE shown below these buttons,

refer to

1 on page 163, “I/O device list.”

DANTE SETUP window

1 Setup method select buttons

Choose one of the following methods for mounting the I/O device.

• NO ASSIGN ........................ Not mounted

• DEVICE LIST...................... Select and mount from the device list

• SUPPORTED DEVICE ....... Select and mount a supported device

• DVS..................................... Enter a device label and mount (only for DVS)

• MANUAL............................. Enter a device label and mount

 When the setup method select button is DEVICE LIST

To mount by choosing from a list of the I/O devices on the Dante audio network, press the

DEVICE LIST button to display the DEVICE LIST field.

1 DEVICE LIST

Shows a list of the I/O devices on the Dante audio network.

From the list, choose the I/O device that you want to mount.

2 DEVICE LIST select knob

Use the [TOUCH AND TURN] knob to select the I/O device that you want to mount.

3 DEVICE IDENTIFY button

If a device has the DEVICE IDENTIFY function, the DEVICE IDENTIFY button is enabled.

Otherwise, this button will be grayed out and cannot be pressed.