User Manual

Input channels
V5 Reference Manual
29
2 HA section (If patched to a wireless mic)
•Frequency
Indicates the frequency that is currently set for the RF signal.
• Signal quality meter
Displays the quality of the received RF signal. The vertical axis represents quality and the
horizontal axis represents time, and the display of connection status is updated every
second. If you move away from the transmitter, or the quality of the RF signal decreases
due to the influence of disturbing radio waves, the bar indication becomes lower. It
displays in purple for Shure devices, and in white for the other developer’s devices.
• RX.GAIN knob/TX.GAIN knob/TX.ATT knob
Sets the HA gain for the transmitter or receiver. The level meter located at the immediate
right of the knob indicates the input level.
The knob name will change depending on the connected device.
• MUTE indicator
Indicates the mute status (on/off) of the audio signal for the receiver.
• RF (Radio Frequency) signal meter
Shows bars to indicate the level of the RF signal.
An active antenna indicator is shown on the right side. It indicates which antenna is
enabled by lighting up.
NOTE
For more information about the relationship between the number of bars and the actual strength
of the RF signal, refer to the manual from each developer.
• Battery indicator
Shows bars to indicate the remaining battery power.
NOTE
For more information about the relationship between the number of bars and maximum operation
time, refer to the manual from each developer.
3 INPUT PORT button
Indicates the port that is assigned to the channel. Press this button to display the PORT
SELECT window, in which you can select a port to patch.
4 Icon/Channel name button
Indicates the channel number, icon, and name. Press this button to access the PATCH/
NAME window, in which you can patch the input port and specify the channel name.
5 AG-DG LINK button
Turns the analog gain and digital gain link on or off. When the link is turned on, the
digital gain is linked to adjustments made to the analog gain, even if Gain
Compensation is on.
6 Ø (Phase) button
Switches between normal and reverse phase settings of signals input.
7 D. GAIN (digital gain) knob
Indicates the digital gain value. You can use the [TOUCH AND TURN] knob to adjust the
digital gain. If the Gain Compensation function is turned on, no changes will be made
to the input level of the analog gain, and therefore the input gain is adjusted with the
digital gain.
8 Digital gain meter
Indicates the level after the signal passes through the digital gain.
9 GC ALL ON button/GC ALL OFF button
Switch Gain Compensation on or off for all input channels simultaneously.
0 AG-DG ALL ON button/AG-DG ALL OFF button
Switch all analog gain and digital gain links on or off simultaneously.