User Manual

Scene memory
V5 Reference Manual
94
*1. The parameters for Insert 1 and Insert 2 are selected together.
*2. Settings are linked according to the channel link for the current scene when the settings are made.
• BUS SETUP tab
You can select the following parameters.
•RACK tab
Enables you to choose from GEQ RACK, EFFECT RACK, or PREMIUM RACK. You can
individually select an GEQ for a Flex15GEQ or an effect used in dual mode.
•PATCH/OTHERs tab
You can select the following parameters.
*1. While in PREVIEW mode, changes that are made in QL Editor are not applied immediately. They are applied
after PREVIEW mode is exited.
•DCA tab
You can select ALL, LEVEL/ON, or NAME. If ALL is selected, all channel parameters will
be copied. If LEVEL/ON is selected, the master level and DCA channel on/off status will
be copied. If NAME is selected, the DCA group name will be copied. You can select the
copy-source channels individually for each DCA group 1-16.
For DCA, although you can turn on both the LEVEL/ON button and the NAME button,
they will then both be switched off if you turn on the ALL button.
EQ EQ settings
DYNA 1 Dynamics 1 settings (including KEY IN SOURCE)
INSERT
*1
Insert on/off status and insert point
INSERT PATCH
*1
Insert in/out patch settings, head amp settings for insert-in
FADER Fader level
CH ON On/off status of [ON] keys
TO ST/BAL TO ST on/off, pan/balance settings
MONO TO MONO on/off status (MIX 1–16 only)
MATRIX SEND Send level, pan, and PRE/POST of the signal sent to a MATRIX bus
MATRIX ON Send on/off to a MATRIX bus
WITH SEND
FROM SOURCE
CHs
SEND parameters of the send-source signal that will be sent to a channel
DCA ASSIGN
*2
Settings registered in DCA group
MUTE ASSIGN
*2
Settings registered in MUTE group
MIX1/2 - 15/16
Sets Recall Safe for MIX 1-16 in the BUS SETUP window. This setting is
applied to a channel pair (one odd-numbered channel and one even-
numbered channel).
MATRIX1/2 - 7/8
Sets Recall Safe for MATRIX 1-8 in the BUS SETUP window. This setting is
applied to a channel pair (one odd-numbered channel and one even-
numbered channel).
SURROUND
SETUP
Surround mode settings.
INPUT PATCH All input channel patches, insert in/out patches, Direct Out patches
OUTPUT PATCH All output channel patches, insert in/out patches
INPUT NAME Channel names, icons, and colors for all input channels
OUTPUT NAME Channel names, icons, and colors for all output channels
HA
Analog gain, phantom power on/off status, Gain Compensation, phase
settings
CH LINK Channel link settings
MUTE GROUP
NAME
Setting a MUTE group name
CUSTOM FADER
BANK
*1
Custom fader bank settings
CASCADE IN CASCADE IN PATCH and CASCADE IN ATT settings
CASCADE OUT CASCADE OUT PATCH settings