User Manual

ManualsBrandsYamaha ManualsAudio MixerQL Series

211

212

213

214

215

216

217

218

219

220

Setup

Reference Manual

219

Specifying the CONSOLE LOCK screen image

If an image file has been saved on the USB flash drive, you can view that image on the

CONSOLE LOCK screen.

In the SAVE/LOAD window, specify the image file that you want to display, and then load it

from the USB flash drive. For details about loading files from the USB flash drive, refer to

“Loading a file from a USB flash drive” on page 222.

NOTE

Supported image file format is BMP in 800 x 600 pixels and 16/24/32-bit, but they will be

converted into 16-bit for display.

Saving and loading setup data to and from a USB

flash drive

You can connect a commercially-available USB flash drive to the USB connector located to

the right of the display, and save the internal settings and user authentication keys of the QL

series console to the USB flash drive or load them from the USB flash drive.

NOTICE

An ACCESS indicator is shown in the Function Access Area while data is being accessed (saved,

loaded, or deleted). During this time, do not disconnect the USB port or power-off the QL unit.

Doing so may damage the data in the flash drive.

NOTE

• Operation is guaranteed only for USB flash drives.

• The operation of USB flash drives with capacities of up to 32GB has been verified. (However, this

does not necessarily guarantee the operation of all USB flash drives.) The FAT16 and FAT32

formats are supported. A USB flash drive with a capacity of 4GB or larger will be formatted in

FAT32, and a USB flash drive with a capacity of 2GB or smaller will be formatted in FAT16.

 Basic operation

SAVE/LOAD window

The list will show the files and sub-directories that have been saved.

1 COPY button

Copies a file into a memory buffer (a temporary holding area).

2 PASTE button

Pastes the file that has been copied into a buffer memory.

3 DELETE button

Deletes the selected file or directory.

NOTE

A directory cannot be deleted unless it is empty. The message “Directory Not Empty!” will appear.

STEP

1. In the Function Access Area, press the SETUP button.

2. In the SETUP screen, press the SAVE/LOAD button.

3. Save/load/edit the data.

SETUP screen

1 2 3 45 6

8 9 0 A BC