User Manual

ManualsBrandsYamaha ManualsAudio MixerQL Series

Input channels

Reference Manual

2 HA section (If patched to a wireless mic)

•Frequency

Indicates the frequency that is currently set for the RF signal.

• RX.GAIN knob

Sets the HA gain for the receiver. The level meter located at the immediate right of the

knob indicates the input level.

NOTE

For more information about the relationship between the number of bars and the actual strength

of the RF signal, refer to the manual from Shure.

• MUTE indicator

Indicates the mute status (on/off) of the audio signal for the receiver.

• RF (Radio Frequency) signal meter

Shows bars to indicate the level of the RF signal.

An active antenna indicator is shown on the right side. It indicates which antenna is

enabled by lighting up.

• Battery indicator

Shows bars to indicate the remaining battery power.

NOTE

For more information about the relationship between the number of bars and maximum operation

time, refer to the manual from Shure.

3 INPUT PORT button

Indicates the port that is assigned to the channel. Press this button to display the PORT

SELECT window, in which you can select a port to patch.

4 Icon/Channel name button

Indicates the channel number, icon, and name. Press this button to access the PATCH/

NAME window, in which you can patch the input port and specify the channel name.

5 AG-DG LINK button

Turns the analog gain and digital gain link on or off. When the link is turned on, the

digital gain is linked to adjustments made to the analog gain, even if Gain

Compensation is on.

6 Ø (Phase) button

Switches between normal and reverse phase settings of signals input.

7 D. GAIN (digital gain) knob

Indicates the digital gain value. You can use the [TOUCH AND TURN] knob to adjust the

digital gain. If the Gain Compensation function is turned on, no changes will be made

to the input level of the analog gain, and therefore the input gain is adjusted with the

digital gain.

8 Digital gain meter

Indicates the level after the signal passes through the digital gain.

9 GC ALL ON button/GC ALL OFF button

Switch Gain Compensation on or off for all input channels simultaneously.

0 AG-DG ALL ON button/AG-DG ALL OFF button

Switch all analog gain and digital gain links on or off simultaneously.

GAIN/PATCH window (8ch)

1 Channel select button

Indicates the channel icon, number, and name. When you press this button, the

corresponding channel will become a target for operations in the SELECTED CHANNEL

section, and the corresponding [SEL] key will light.