User Manual

Input channels

Reference Manual

6 TO ST PAN/TO ST BALANCE knob

For an INPUT channel (monaural), this acts as a PAN knob that adjusts the left/right

panning of signals sent to the STEREO bus. For a ST IN channel (stereo), this acts as a

PAN knob, and also as a BALANCE knob that adjusts the volume of the left and right

signals sent to the STEREO bus. To adjust the value, press the knob to select it, and then

operate the [TOUCH AND TURN] knob.

7 Tabs

Enable you to switch between windows.

8 LCR button

If the MODE button is set to LCR mode, this button is displayed instead of 4. This

button is an overall on/off button for signals sent from a channel to the STEREO bus and

MONO bus. If this button is off, no signals will be sent from the corresponding input

channel to the STEREO bus or MONO bus.

9 CSR knob

Adjusts the relative level of signals sent from the channel to the STEREO (L/R) bus and

to the MONO (C) bus, in the range of 0–100%. To adjust the value, press the knob to

select it, and then operate the [TOUCH AND TURN] knob (page 37).

Added pan function (Monaural input channels only)

The pan setting for signals sent to the STEREO bus enables you to select PAN LAW settings.

You can select one of the following:

NOTE

The settings are also applied to the signals sent to the stereo MIX buses.

CENTER NOMINAL

The pan level is nominal at center and +3dB when panned 100%

either left or right.

LR NOMINAL

The pan level is -3dB at center and nominal when panned 100%

either left or right.

STEP

1. Select a monaural input channel.

2. In the STEREO/MONO field, press a knob to select the channel you want to adjust in

the OVERVIEW window, and then press the knob once again. Or, in the PAN/

BALANCE field, press a knob to select the channel you want to adjust in the

SELECTED CHANNEL window, and then press the knob once again.

3. Use the PAN LAW select button in the TO STEREO/MONO window to set the PAN

LAW for each channel.