User Manual

Input channels

Reference Manual

1 PAN LAW select button

This toggle button is used to set the PAN LAW for the Input Channel.

For CENTER NOMINAL For LR NOMINAL

NOTE

PAN LAW settings are also enabled in LCR mode. They are also enabled in Surround mode.

ou can also check the status of PAN LAW settings in the window shown below. For channels

where the mark is on, PAN LAW is set to LR NOMINAL.

• TO STEREO/MONO window (CH1–32, CH33–64/ST IN (QL5), ST IN (QL1))

• OVERVIEW window (STEREO/MONO field)

• SELECTED CHANNEL VIEW window (PAN/BALANCE field)

TO STEREO/MONO window

(CH1–32, CH33–64/ST IN (QL5), ST IN (QL1))

Adjusts the status of a signal sent from the corresponding input channel to the STEREO/

MONO bus. You can also adjust the selected pan or balance setting.

1 Channel select button

Selects the channel. You can select multiple channels simultaneously.

2 Σ clipping indicator

Lights to indicate a signal is clipping at some point in the channel.

3 TO ST PAN/TO ST BALANCE knob

Adjusts the panning or balance.

To adjust the value, press the knob to select it, and then operate the [TOUCH AND

TURN] knob.

If the signal reaches the overload point at any meter detection point in that channel,

the Σ indicator to the right of the knob will light.

4 ST/MONO indicator

If a channel is set to ST/MONO mode, these indicators will individually indicate the on/

off status of signals sent from the channel to the STEREO bus/MONO bus.

If that channel is set to LCR mode, the LCR indicator will be displayed in this location.

The LCR indicator indicates the on/off status of all signals sent from that channel to the

STEREO bus/MONO bus.