User Manual

Channel Job

Reference Manual

NOTE

In the case of the QL1, faders that do not exist on the model will not be shown.

3 MOVE button

Executes a move operation. After selecting the move-source channel and

move-destination channel, the channel settings move from the move-source to the

move-destination. The settings of all channels between the move-source and

move-destination will shift toward the move-source by one channel.

4 CLOSE button

Press this button to close the window and return to the previous screen.

Initializing the parameters of a channel

You can restore the parameters of a channel to an initialized state. This operation can be

performed on any channel(s).

NOTE

After initialization, the TARGET CHs field will be empty (nothing is selected).

CH DEFAULT MODE window

Enables you to initialize parameters.

1 TARGET CHs fie ld

Indicates the channel selected for initialization. While this window is displayed, press a

[SEL] key on the top panel to select an input channel (multiple selection is allowed). The

field will indicate the selected channel(s). Press the same [SEL] key once again to

de-select the channel.

NOTE

• If you press this field while a channel is selected, all selected channels will be de-selected.

• In the case of the QL1, faders that do not exist on the model will not be shown.

2 DEFAULT button

After selecting the channel, press this button to execute the initialization operation.

STEP

1. In the Function Access Area, press the CH JOB button.

2. Press the DEFAULT button in the CH JOB menu.

3. Press the [SEL] key of the channel(s) to be initialized to make it light (multiple

selections are allowed).

4. Press the DEFAULT button to execute the Initialization.

CH JOB

Function

Access Area