User Manual

QL Editor Owner’s Manual

5 HA (HA analog gain)

Adjusts the analog gain for INPUT. This knob appears only if the channel is patched to a head amp.

6 48V (Phantom power)

Switches phantom power (+48V) on/off. This button appears only if the channel is patched to a head amp.

7 GC (Gain Compensation)

Turns head amp analog gain compensation on/off.

❏ DIRECT OUT (except for ST IN channels)

1 ON

Turns the direct output on/off. You can right-click (<control> key + click) the button to display a popup menu and

select ALL ON or ALL OFF.

2 DIRECT OUT GAIN

Adjusts the gain of the direct output. The current value is shown in the numerical box below the knob. You can set this

to the nominal value (0.0 dB) by holding down the <Ctrl>(< >) key and clicking the knob.

3 DIRECT OUT PORT

Click this to select one of the following output ports as the one used for direct out.

4 DIRECT OUT POINT

Selects the position at which direct out will be patched. Choose from PRE HPF, PRE EQ, PRE FADER, or POST ON.

NONE No assignment

DANTE 1–32, DANTE 33–64 (only QL5) DANTE OUTPUT 1–32, DANTE OUTPUT 33–64 (only QL5)

OMNI 1–8, OMNI 9–16 (only QL5) OMNI OUT jacks 1–8, OMNI OUT jacks 9–16 (only QL5)

REC L, REC R L/R inputs of RECORDER

SLOT1-1, SLOT1-2...SLOT2-16 Output channels of an I/O card installed in slots 1–2

DIGI L, DIGI R L/R channels of the DIGITAL OUT jack

23 4