User Manual

QL Editor Owner’s Manual

1 Link buttons

Use these buttons to select the link group A-Z, a-n to which you want each input channel to be assigned. If you don’t

want an input channel to be linked, select NONE. You can assign up to forty groups for INPUT CH 1–64 (QL1: 1–32

and ST IN CH 1–8.)

2 CLEAR ALL

Clears the link settings for all channels.

3 LINK GROUP button

If you select a link group using one of the corresponding Link buttons (1), the LINK GROUP button will automati-

cally select the same link group.

4 LINK PARAMETER

This section enables you to select the parameters to interlock.

The HA, FADER, DIGITAL GAIN, and DELAY parameters will maintain level differences between linked

channels.

5 SEND PARAMETER

Specify the link status for each MIX/MATRIX SEND bus.

HA Head amp gain and phantom power settings

HPF HPF settings

DIGITAL GAIN DIGITAL GAIN settings

EQ Equalizer settings

DYNAMICS1 Dynamics 1 settings

DYNAMICS2 Dynamics 2 settings

INSERT INSERT settings

DIRECT OUT DIRECT OUT settings

MIX SEND Send amount from input channel to MIX bus

MIX ON MIX SEND on/off

MATRIX SEND Send amount from input channel to MATRIX bus

MATRIX ON MATRIX SEND on/off

FADER Fader level value

DCA DCA settings

CH ON Input channel module output on/off

MUTE Mute settings

TO ST TO ST settings

DELAY Delay settings

NOTE