User Manual

ManualsBrandsYamaha ManualsAudio MixerQL Series

151

152

153

154

155

156

157

158

159

160

I/O devices and external head amps

Reference Manual

152

I/O DEVICE screen (I/O page)

1 Display switch buttons

Press one of these buttons to view the corresponding I/O device. If you press and hold

down this button, all LEDs of the corresponding I/O device will blink.

For more information about VIRTUAL/CONFLICT/DUPLICATE displayed below this

button, refer to

1 on page 149, “I/O device list.”

2 ID/Model name display

This shows the ID number, model name, and version of the I/O device.

If the WITH RECALL button is turned ON in the REMOTE HA SELECT screen, “w/RECALL”

is displayed. If the +48V MASTER switch for the mounted device is turned ON,“+48V

MASTER” is displayed.

3 DANTE SETUP button

Press this button to open the DANTE SETUP window, in which you can make settings

for the audio network.

4 SYSTEM/SYNC indicators

Error, warning, and information messages are displayed. Refer to the list (page 228) for

detailed information about messages.

 HA display

This shows the HA settings of the I/O device. Press this area to open the I/O DEVICE HA

window, in which you can make detailed head amp settings.

If you press the [SEL] key of an input channel, the corresponding port will light. (It does not

light for external QL series consoles.)

5 Analog GAIN knob

Indicates the analog gain setting. This screen is only for display; the value cannot be

edited.

6 +48V indicator

Indicates the phantom power (+48V) on/off status for each port.

7 OVER indicator

Warns you when the input signal is clipping.

8 HPF indicator

Indicates the high-pass filter on or off status for each port.

 INPUT display

This shows the input settings of I/O devices not assigned to REMOTE HA ASSIGN.

If you press the [SEL] key of an input channel, the corresponding port will light. (It does not

light for external QL series consoles.)

 OUTPUT display

This shows the output settings of the I/O device. Press here to access the OUTPUT PATCH

window, where you can make output port settings for the I/O device.

If you press the [SEL] key of an output channel, the corresponding port will light. (It does not

light for external QL series consoles.)

1 2