User Manual

Setup
Reference Manual
200
NOTE
• If you are logged-in as the Administrator, you can also turn on the FOR GUEST button to access
the SOFTWARE USER DEFINED KNOBS for Guest page and make USER DEFINED knob
settings for the Guest account.
• The four buttons in the SOFTWARE USER DEFINED KNOBS page correspond to USER
DEFINED knobs [1]–[4] in the lower part of the touch screen. The name of the function or
parameter assigned to each knob appears to the right of the corresponding button. If nothing is
assigned to the knob, an indication of “---” will appear next to the button.
• The list shown in the USER DEFINED KNOB SETUP window is the same for all models of the QL
series.
For the QL1, the display will indicate “Cannot Assign!” if you specify a parameter that does not exist
on that model.
• If there are no parameters for the registered USER DEFINED key, nothing will occur when the key
is operated.
About TOUCH AND TURN
You can press a desired knob in the touch screen and then use the
[TOUCH AND TURN] knob to immediately operate that on-screen
knob.
At this time, a pink frame is shown around the knob in the touch
screen, indicating that you can operate that knob.
Functions that can be assigned to
USER DEFINED knobs
Function PARAMETER 1 PARAMETER 2
NO ASSIGN — —
AUTOMIXER WEIGHT *1)
BRIGHTNESS
LAMP —
PANEL —
SCREEN —
CH COLOR —
NAME —
CUE
INPUT PFL TRIM —
DCA TRIM —
OUTPUT PFL TRIM —
CUE LEVEL —
DIRECT OUT LEVEL LEVEL *14)
DYNAMICS1
THRESHOLD *2)
RANGE *4)
RATIO
*2)
ATTACK
HOLD
*4)
DECAY
RELEASE
*2)OUTGAIN
KNEE
WIDTH *13)
DYNAMICS2
THRESHOLD
*4)
RATIO
FREQUENCY
ATTACK
RELEASE
OUTGAIN
KNEE
WIDTH
EFFECT
Displays the EFFECT RACK No. (1-8) for
the target operation as well as the
name of the mounted EFFECT TYPE or
the name of the GEQ/PEQ TYPE *a).
Displays the names of the 32
parameters for the EFFECT TYPE *b).
Displays “----” if a GEQ/PEQ is
mounted.
EQ
ATT
*2)
LOW Q
LOW FREQUENCY
LOW GAIN
LOW MID Q
LOW MID FREQUENCY
LOW MID GAIN