User Manual

Input and output patching

Reference Manual

DIRECT OUT screen (8ch)

1 DIRECT OUT ON button

Switches the Direct Out on or off. The currently-selected Direct Out point is indicated

above the button.

2 DIRECT OUT PATCH button

Displays the currently-selected Direct Out output port. Press this button to open the

PORT SELECT window, in which you can select an output port.

3 DIRECT OUT LEVEL knob

Indicates the output level of the Direct Out. You can use the [TOUCH AND TURN] knob

to adjust the level.

4 Close button

Closes the screen.

PORT SELECT window

Displayed when you press the DIRECT OUT PATCH button in the one-channel or the eight-

channel INSERT/DIRECT OUT window. Set the output port used for direct output.

1 Category select list

Selects the category of output port. The categories correspond to the following output

ports. The displayed categories vary depending on the channel type.

• OUTPUT/DIGITAL/REC.........OMNI OUT1–OMNI OUT16 (QL5), OMNI OUT1–OMNI

OUT8 (QL1), DIGITAL OUT L/R, RECORDER IN(L/R)

• SLOT1....................................SLOT1(1)–SLOT1(16)

• SLOT2....................................SLOT2(1)–SLOT2(16)

• DANTE1–32...........................DANTE1–DANTE32

• DANTE33–64.........................DANTE33–DANTE64 (QL5 only)

2 Output port select buttons

Assign the output port used for direct output of the currently-selected INPUT channel.

3 CLOSE button

Closes the window.