User Manual
Table Of Contents
- Contents
- What you can do using ProVisionaire Touch
- Operating requirements of the software
- Terms and concepts to understand
- Installation procedure
- Startup
- Basic process
- Operations for common settings
- About the menu bar
- Settings file management — the File Management button
- Selecting multiple widgets — Multi Select button
- Creating a custom panel — the Page Edit button
- Widget design
- Assigning parameters
- Switching pages — the Page Selection button (Control mode)
- Managing pages — the Page Management button (Design mode)
- Registering devices to control — the Device Management button
- Control panel settings — the Setup button
- Control panel information — the Information button
- Preparations before you make connections
- Troubleshooting
- About the software license
74
Example network settings for the iPad
1. In the home screen of the iPad, tap [Settings] [Wi-Fi].
2. Turn the [Wi-Fi] switch On ( ), and from the access
point list that appears, select the access point of the
target system.
3. Enter the password of the Wi-Fi access point.
4. Make network settings.
If obtaining the IP address automatically
1. Tap , and set [Configure IP] to [Automatic].
2. Verify that “IP Address,” “Subnet Mask,” “Router,” and “DNS”
are set.
3. Click the home button to complete the settings.
If specifying the IP address manually (when it can-
not be obtained automatically)
1. Tap , and set [Configure IP] to [Manual].
2. In “IP Address,” enter the IP address of the target system,
changing only the fourth octet (in the illustration above,
“200”).
3. In “Subnet Mask,” enter “255.255.255.0.”
4. In “Router,” enter the IP address of the router or the IP
address of the Wi-Fi access point.
5. In “DNS,” enter the IP address of the DNS or the IP address
of the Wi-Fi access point.
6. Click the home button to complete the settings.