User guide

5
2 Networking Your StudioLive AI Loudspeaker
2.2 Step 2: Updating Your Loudspeaker Firmware
SL-Dante-SPK
User Guide
11.
On
Press and Hold
any button
Power on your StudioLive AI loudspeaker while holding down any button
on its back panel.
12.
1 Louisiana
2 Louisiana
3 Louisiana
4 Louisiana
5 Louisiana
Continue holding the button for 10 full seconds (1-Louisiana,
2-Louisiana, etc.).
13. The lights on the back panel of your StudioLive AI loudspeaker will
cycle until the rmware update is complete. The rmware update
takes approximately ve minutes. When the update is complete, your
loudspeaker will reboot. Once the rmware update is complete, you can
remove the thumb drive.
You must update the rmware on every loudspeaker into which you are
installing an SL-Dante-SPK.
Power User Tip: It is highly recommended that you take note of both the
SL-Dante-SPK’s and the loudspeaker’s serial number so you know which option
card is in which speaker. You can manage this through registrations in your My
PreSonus account.