User Manual

Alert list
16 MCP1 (Ver. 5.0 or later) Installation Manual
For other alerts, refer to “Alert list for MTX5-D/MTX3” in the “ProVisionaire Design User Guide.”
070
Synchronization has not been
completed. It may be that syn-
chronization was halted before
completion.
Perform synchronization again
using ProVisionaire Design. If
this does not solve the problem,
initialize the MCP1.
Error Continuing
071
The UNIT ID settings when
synchronization was per-
formed do not match the cur-
rent UNIT ID settings.
Do not change any UNIT ID’s
after performing synchroniza-
tion. If you’ve changed any
UNIT ID’s, perform synchroniza-
tion again.
Error Continuing
Number Content Action Type
Single /
Continuing