User Manual

6 MCP1 (Ver. 5.0 or later) Installation Manual
Introduction
Thank you for purchasing a Yamaha MCP1 wall-mount controller. This product enables
you to control Yamaha devices as well as products manufactured by other companies
that have released compatible remote protocols. This installation manual explains how
to mount the unit when the installing technician or the designer installs or sets-up the
system. In order to take full advantage of this product’s many functions, be sure to read
this installation manual before installation.
After reading this manual, keep it for future reference.
The MCP1 lets you set up a home page and six pages, and assign up to 36 parameters.
What you’ll need to provide
When attaching the MCP1 to a wall, you’ll need to provide several items.
• PoE injector or PoE network switch that supports IEEE802.3af
This is used in order to supply power to the MCP1.
PoE injector units and PoE network switches are collectively referred to as “PSE (Power
Sourcing Equipment).”
• Ethernet cables (CAT5e or better)
These cables are used to connect to the PSE.
• (If embedding the unit in the wall)
2-gang box (without separator; 20 mm or greater depth)
You’ll also need screws for attaching the gang box to the wall.
• (If using a surface mount box)
Screws for attaching the surface mount box to the wall × 4
Provide M4.0 flat head screws of a length appropriate for the thickness of the wall.
• Phillips screwdriver / electric screwdriver
This is used for installation.