User guide

Dugan-MY16 User Guide Installation and Linking
15
To configure and install the Dugan-MY16 card:
1. Set the 48 kHz–96 kHz sample rate switch according the table below.
The sample rate switch represents low (44.1 or 48 kHz) and high (88.2 or 96 kHz)
settings, respectively, that must correspond to your mixer’s current sample rate.
For example,
If your mixer is set to 44.1 kHz, use the 48 kHz position.
If your mixer is set to 88.2 kHz, use the 96 kHz position.
Figure 2-1 Circuit board and rear panel switches
2. Install the Dugan-MY16 card according to the instructions in your mixer’s user
guide.
3. Turn on the mixer.
If you are using Shared mode, an appropriate synchronization source must be
selected for channels 9–16. See your Yamaha mixer’s user guide for details.
4. Press and hold the RESET button for 3 seconds to restore the Dugan-MY16’s factory
default settings.
5. Set the rear panel LINK–AUDIO switch to the position corresponding to the selected
operating mode (see table above).
6. Set the NORM–SLAVE switch to NORM (up) for unlinked operation.
Mixer Sample
Rate
Sample Rate
Switch
LINK-AUDIO Switch
Standard
44.1 kHz 48 kHz LINK
48 kHz 48 kHz LINK
High Rate
88.2 kHz 96 kHz LINK
96 kHz 96 kHz LINK
Shared
44.1 kHz 48 kHz AUDIO
48 kHz 48 kHz AUDIO