manual
I/O devices and external head amps
V5 Reference Manual
169
4 SLOT 1 - 4 SRC indicators
Indicate the Sampling Rate Converter (SRC) status for slots 1 to 4.
NOTE
Use the SRC WCLK DIP switches on the RSio64-D to set the SRC clock sent to the Mini-YGDAI
card inserted in the slot.
5 SLOT 1 to 4 SRC buttons
Used to turn SRC on/off at both IN and OUT for each slot.
6 WCLK indicator
If the card’s internal sampling rate converter function is enabled when an MY8-AE96S
mini-YGDAI card is inserted into the RSio64-D, “CARD” is displayed.
If the card’s internal sampling rate converter function is disabled, “SLOT” is displayed.
7 WORD CLOCK select button
Used to select the word clock source for the RSio64-D.
• WORD CLOCK WCLK IN indicator
• WORD CLOCK SLOT1 1/2 indicator
• WORD CLOCK DANTE indicator
Indicates the word clock source status for the RSio64-D.
*1 When flashing, Dante word clock
*3
input/output is used.
*2 If you are using MY8-AEB, set the AERSVD switch for the card to RSVD.
*3 If you make changes to the frequency of the Dante word clock, use Dante Controller.
8 CURRENT PATTERN button
If you press this button, the currently selected routing pattern on the RSio64-D is
displayed. If you switch the routing pattern on the RSio64-D, it will be applied in 3
seconds.
Green
(Flashing)
SYNC
ERROR
A valid clock is being input from the card, but is not synchronized with the
clock source selected with the [WORD CLOCK] select key. If an external
device is connected to the corresponding slot, input/output cannot occur
correctly between that device and the RSio64-D. Turn SRC ON for correct
input/output.
Red (On)
UNLOCK
A valid clock is not being input from the card. If an external device is
connected to the corresponding slot, input/output cannot occur correctly
between that device and the RSio64-D.
Red
(Flashing)
WRONG
WORD
CLOCK
The frequency of the clock source selected with the [WORD CLOCK] select
key is outside of the operating frequency range for the card inserted in the
slot. Either set the frequency of the clock source within the operating range
for the card, or turn [SRC] ON. For an analog card, if you turn [SRC] ON, the
frequency is set to the 48kHz built into the RSio64-D.
Off SRC is off.
Green (On)
SRC is on, and the clock selected with the SRC WCLK DIP switches on the
RSio64-D is being input correctly.
Red (On)
SRC is on, but an appropriate clock is not being input. The clock selected
with the SRC WCLK DIP switches on the RSio64-D is either not being input
or is not within the operating range. Either turn SRC off, or change the DIP
switch settings.
WCLK IN
On when using the word clock signal being input from the WORD
CLOCK IN connector on the rear panel of the RSio64-D. Flashes
*1
if
there is no valid word clock input.
SLOT1 1/2
On when using the word clock for channels 1/2 of slot 1 for the RSio64-
D. Flashes
*1
if there is no valid word clock input. When using MY8-
AEB
*2
, the word clock for channels 7/8 is used.
DANTE
On when using the word clock for the Dante network
*3
. (If there is no
valid Dante signal input, the internal Dante module will generate a
clock.)