Owner's Manual
Table Of Contents
- Contents
- PRECAUTIONS
- Introduction
- An overview of the QL series
- Controls and functions
- Touch screen
- Basic operation of the QL series
- Connection
- Quick Guide
- Connecting the devices
- Setting the input channels
- Sending an input channel signal to the STEREO bus
- Applying EQ/dynamics
- Setting the output channels
- Using GEQ
- Using Automixer
- Applying effects
- Changing the patch settings
- Grouping and linking
- Using talkback
- Routing the oscillator to an output channel
- Using scene memories
- Recording and playing audio using a USB flash drive
- Saving and loading the unit settings
- Other functions
- Troubleshooting
- Attaching the RK1 rackmount kit (sold separately)
- General specifications
- Dimensional Diagrams
- Index
- Block Diagram
- Level Diagram
Attaching the RK1 rackmount kit (sold separately)
Owner’s Manual
50
Attaching the RK1 rackmount kit
(sold separately)
You can attach the optional RK-1 rackmount kit to the QL5 and QL1 and mount it in a rack or an installed system.
1. Make sure that the power is turned off.
2. Remove screws “A” and detach the side pads.
NOTE
Keep the side pad screws together with the pads you removed.
3. Use the screws included with RK1 to install the hardware.
Tighten the screws at the locations indicated by the arrows.
4. Attach the hardware to the other side in the same way.
NOTICE
When attaching the RK1 rackmount kit, you must turn off the power switch on the unit and use the screws that are included with the
RK1. Otherwise, malfunctions or electric shock may occur.
A
A
A
Side Pads