manual

Recorder
Reference Manual
180
1 Setup method select buttons
Choose one of the following methods by which to specify DVS or Dante Accelerator.
• NO ASSIGN ........................ Not assigned
• DVS ..................................... Select a DVS from the device list
• SPECIFIED IP ADDRESS .. When using Dante Accelerator, specify the IP address of
the computer
 When setup method selection button = DVS
To choose from a list of the I/O devices on the Dante audio network, press the DVS button to
display the DEVICE LIST field.
1 DEVICE LIST
Shows a list of the I/O devices on the Dante audio network.
From the list, choose the DVS that you want to use with Nuendo Live.
2 DEVICE LIST select knob
Use the [TOUCH AND TURN] knob to select the DVS to switch to.
 When setup method selection button = SPECIFIED IP ADDRESS
When using Dante Accelerator, specify the IP address of the computer in the SPECIFIED IP
ADDRESS field. Since the IP address of Dante Accelerator will differ from the IP address used
by Yamaha Console Extension, you must specify the IP address manually.
1 IP ADDRESS knobs
Use the [TOUCH AND TURN] knob to specify an IP address.
NOTE
• As the IP address, specify the IP address of the computer that is running Nuendo Live.
• Set the address of that computer in the range of 169.254.0.0–169.254.255.255, and set the
subnet mask as 255.255.0.0.
• For the computer in which Dante Accelerator is installed, the Dante port of Dante Accelerator as
well as the Ethernet port of the computer must both be connected to the same network.
Refer to the illustration below.
1
2
1
Computer
SW
(Primary)
SW
(Secondary)
Ethernet
Dante Accelerator
P
S
QL
Dante
P
S