manual

Monitor and Cue functions
Reference Manual
104
8 MONITOR FADER field
Enables you to set and view the monitor fader that adjusts the monitor level.
• MONITOR FADER LEVEL knob
Adjusts the monitor fader level. You can use the [TOUCH AND TURN] knob to adjust the
monitor level.
• FADER ASSIGN display
This area displays the type of faders that are currently assigned as MONITOR FADER.
Indicator assignments are as follows.
9 MONITOR DELAY field
This field enables you to specify the monitor delay setting by which the monitor out
signal is delayed.
• AUTO BYPASS button
Turn this on to automatically bypass monitor delay when the cue is on.
• MONITOR DELAY knob
Adjusts the delay time for the monitor signal. The delay time is shown above the knob
in ms units, and below the knob in units of the currently-selected scale. However if the
scale is set to ms, the delay time value is not shown above the knob.
If you press this knob, you can use the [TOUCH AND TURN] knob to adjust the value.
• MONITOR DELAY ON button
If this button is on, the monitor signal will be delayed according to the setting of the
MONITOR DELAY knob.
0 Meter field
•Meters
Indicates the output level of the monitor L/R/C channels.
*1. QL1: 1–32
*2. QL1: 1–8
NOTE
• You can specify output ports only for MONITOR OUT L and R, and monitor through two speakers.
• If you have not specified an output port for MONITOR OUT C, selecting the MONO (C) button or
LCR button as the monitor source will automatically cause the MONO channel signal to be
distributed to MONITOR OUT L/R.
A ASSIGN field
If you have selected DEFINE in the SOURCE SELECT field, you can use the ASSIGN field
to specify multiple monitor sources. The following table shows the monitor sources that
you can select in the ASSIGN field.
*1. QL1: 9-10–15-16
*2. QL1: 9–16
NOTE
You can select a maximum of eight monitor sources in the ASSIGN field. If you select eight
monitor sources, no further selections will be possible. Turn off the buttons of unneeded sources.
---- No assignment
MASTER A MASTER A fader only
MASTER A+ MASTER A, as well as MASTER B fader and Custom fader bank
MASTER B MASTER B fader only
MASTER B+ MASTER B, as well as Custom fader bank
CUSTOM One of the Custom fader bank faders
CUSTOMs Multiple Custom fader bank faders
DANTE1–64
*1
Output channels 1–64 to audio network
*1
OMNI1–16
*2
OMNI OUT jacks 1–16
*2
DIGI OUT L/R DIGITAL OUT jack on the QL unit
SLOT1-1–SLOT2-16 Output channels 1–16 of an I/O card installed in slots 1–2
MIX 1–16 MIX channels 1–16 output signals
MTRX 1–8 MATRIX buses 1–8 output signals
STEREO STEREO L/R channel output signals
MONO (C) MONO channel output signal
PB OUT Recorder’s PLAYBACK OUT signals
INPUT 25-26–31-32
*1
INPUT jacks 25–32
*2
signals (per two channels)
PORT SELECT window