manual
Talkback and Oscillator
Reference Manual
115
Talkback and Oscillator
Talkback is a function that sends the signal of the selected INPUT jack to the desired bus. This
is used mainly to convey instructions from the operator or sound engineer to the performers
and staff.
QL series consoles also feature an oscillator that can output a sine wave or pink noise to the
desired bus, so that you will be able to check external equipment or to test the acoustical
response of the room or hall.
The diagram below shows the signal flow of the talkback and oscillator signals.
Using Talkback
The Talkback function sends the signal (that is input at the input jacks) to the desired bus.
NOTE
• The PAD will be switched on or off internally when the HA gain is adjusted between +17 dB and
+18 dB.
• Keep in mind that noise may be generated when using phantom power if there is a difference
between the Hot and Cold output impedance of an external device connected to the INPUT jack.
• You can also assign talkback on/off or an ASSIGN change to a USER DEFINED key. In this case,
you can select either a Latch operation or an Unlatch operation (the function will be enabled only
while you continue holding down the key) (page 208).
• When talkback is on, you can use the talkback dimmer to lower the monitor levels other than the
talkback signal (page 103).
64{32}
SLOT1 1-16
SLOT2 1-16
CASCADE IN
TALKBACK
INPUT
SELECT
ON
DANTE IN 1-64{32}
INPUT 1-32{16}
MIX
12 15
...
16
ST
LR
M
O
N
O
(C)
MATRIX
(USE 7-8
AS CUE B)
12 78
...
CUE(A)
LR
[INPUT]
[1-32{16}]
METER
HA
[DANTE]
DANTE
INPUT
METER
DANTE
IN
32{16}
DANTE IN 1-64{32}
INPUT 1-32{16}
+48V
+48V MASTER
ON
+48V
ADINPUT
+
-
1
2
3
GAIN/TRIM
METER
PRE GC
Compensation
Gain
To CH 1-64{32},ST IN 1L-8R
LEVEL
ON
HPF
LPF
METER
OSC
OSCILLATOR
Pink Noise
Burst Noise
Sine Wave
Sine Wave 2CH
CASCADE
IN
SELECT
STEP
1. In the Function Access Area, press the MONITOR button.
2. Press the TALKBACK display button or the ASSIGN field in the MONITOR screen.
3. Connect a mic to the INPUT jack on the rear panel.
4. Press a button in the ASSIGN field in the TALKBACK window to specify the bus(es)
to which the talkback signal will be sent (multiple selections are allowed).
5. To enable talkback, press the TALKBACK ON button to turn it on.
6. Press the INPUT TO TALKBACK button to select an input. Use the [TOUCH AND
TURN] knob to adjust the volume.
MONITOR screen