manual

I/O devices and external head amps

Reference Manual

165

Third-party equipment’s HA control function

It is possible to control supported third-party equipment’s head amps (HA) from the console.

You can control HA by registering supported devices in the DANTE SETUP window.

NOTE

While in PREVIEW mode, changes made to HA parameters from the console are not applied to

the device.

You can turn “WITH RECALL” on and off in the REMOTE HA ASSIGN window.

You can store/recall scene libraries and save/load files.

You can register up to 8 devices, including R series units. You can also register a device that

has the same UNIT ID as a device that is already registered, including R series units. You can

adjust HA parameters in advance, even when a connection is not established with the device

to be controlled.

You can control the following parameters.

1 HA phantom power (+48V) on/off

2 HA gain

3 Head amp HPF on/off

NOTE

The indicator on the right side of the rack indicates the control status of the device.

You can perform the following operations from input channels patched to the target device:

• Store/recall input channel library

• Channel jobs (channel link, etc.)

• HA controls at user level (only when operating HA from an input channel)

• AG-DG LINK

NOTE

You cannot perform this operation on devices that do not support Gain Compensation.

Searching for device to be controlled

Connecting to device

Synchronizing with device

Device can be controlled

Found device to be controlled, but connection refused