manual

ManualsBrandsYamaha ManualsAudio MixerQL5

Channel Job

Reference Manual

4 SEND PARAMETER field

If you have turned on the MIX ON, MIX SEND, MATRIX ON, or MATRIX send buttons

in the LINK PARAMETER field, use the buttons in this field to specify the send-destination

bus(es).

NOTE

If nothing is selected in the SEND PARAMETER field, send on/off and send level will not be

linked.

5 INPUT/OUTPUT button

Use this button to switch between the Input Channels screen and the Output Channels

screen.

 Channel link operations

• Linking three or more channels

Hold down the link-source [SEL] key and successively press the [SEL] key of each channel

you want to add to the link group.

• Adding a new channel to an existing link group

Hold down any [SEL] key within the group and press the [SEL] key that you want to add

to the group.

NOTE

If the link-destination channel is already assigned to another link group, its assignment to the

previous group will be canceled, and it will be added to the newly assigned group.

• Removing a channel from a link group

Hold down any [SEL] key in the same link group, and press the [SEL] key for the channel

that you want to remove.

• Changing the level balance between channels that belong to the same link group

While pressing and holding down the [SEL] key for the desired linked channel, adjust the

parameter value. You can also remove all linked channels from the same link group

temporarily. This can be helpful if you want to edit parameters that are linked to each

other while maintaining the same relative level differences. For example, this may be the

case for parameters such as the HA analog gain and fader. While you are holding down

the [SEL] key, the HA analog gain and fader values will not be linked. (However, you

cannot temporarily cancel this link during the “fading” phase of a recalled scene.)

CH LINK MODE window (output channels)

You can view the output channels that are linked and specify the parameters that will be

linked.

1 Output channel display field

When you create a link group, the corresponding output channels will be highlighted.

If there are two or more link groups, each group is shown in a different color. Press this

field to open the CH LINK SET window. You can also link output channels in this window.

NOTE

In the case of the QL1, faders that do not exist on the model will not be shown.

2 Link indicator

If an output channel belonging to a link group is selected, the associated link group is

shown. The LINK PARAMETER field and SEND PARAMETER field show the link settings.

While you hold down the [SEL] key of an output channel that does not belong to any

link group, the link indicator shows the link group that will be created next. The LINK

PARAMETER field and SEND PARAMETER field show the settings of the link group that

had been previously displayed.

MIX1–16 MIX buses 1–16

MTRX 1–8 MATRIX buses 1–8