manual

Input channels

V3.1 Supplementary Manual

You can also check the status of PAN LAW settings in the window shown below. For channels

where the mark is on, PAN LAW is set to LR NOMINAL.

• TO STEREO/MONO window (CH1–32, CH33–64/ST IN (QL5), ST IN (QL1))

• OVERVIEW window (STEREO/MONO field)

• SELECTED CHANNEL VIEW window (PAN/BALANCE field)

Changing input signal processing when setting LR-

MONO (Stereo input channels only)

In order to ensure the appropriate level, the signal processing regarding the LR-MONO setting

has been changed as follows. Although the result is a monaural signal that is the summation

of signals from both channels, the R channel of the stereo input channel is muted.

NOTE

• When you set LR-MONO, the PAN mode is selected at the same time. In addition, the PAN knob

is set to the center position.

• When you set LR, L-MONO, or R-MONO, the BALANCE mode is selected at the same time. In

addition, the BALANCE knob is set to the center position.