Specifications
37
Programming the Sequencer Parts
3. Assign a Voice to the Selected Part
With the cursor either at the PART pointer or the voice name, use
the [-1] and [+1] buttons to select the voice you want to use for
the selected part.
DETAIL
• You can also set the volume of the selected part by moving
the cursor to the VOLUME parameter below the voice name
and using the
[-1][-1]
[-1][-1]
[-1] and
[+1][+1]
[+1][+1]
[ + 1 ] buttons to set a value between
0 (no sound) and 127 (maximum volume). This is a good way
to balance the volumes of the various voices used for the four
parts.
• Complete lists of the QY8 voices and drum instruments are
provided in the “Appendix” on pages 71, 72.
• To create a drum part select voice number “41” and enter the
notes corresponding to the drum instruments you want to use.
Refer to the voice list on page 72 for drum-to-note assign-
ments.
4. Set a Key Signature
Move the cursor to the key signature on the display “score”, use
the [-1] and [+1] buttons to select the key you want to use for
your song, then press [ENTER] to actually enter the selected key
signature.
C G D A E B F
F B E A D G C
C
Key Signature List
35SyCmp
100