Specifications

The Option Functions

3. Use the [-1] and [+1] buttons to select the first source part to be

mixed: “P1” … “P4” are parts 1 through 4.

4. Move the cursor across to the second source part parameter and

use the [-1] and [+1] buttons to select the second source part to be

mixed.

5. Move the cursor down to the destination part parameter and

use the [-1] and [+1] buttons to select the part to which the mixed

source parts are to be copied.

6. Press [ENTER] to mix and copy the specified parts. “Completed”

will appear briefly on the display and the Mix Part function will

automatically be exited when the specified data has been mixed

and copied. You can exit without executing the Mix Part function

by moving the cursor up to the OPTION pointer.

MUSICAL

NOTE

In many situations you may want to “overdub,” or add new

material to a single part without deleting the previous material.

This is dangerous, however, since you can ruin one or more layers

of good material by making a mistake during a later overdub. The

QY8 eliminates this possibility by allowing only “replace” recording

(i.e. all material recorded to a part erases and replaces any

previous material on that track). In order to record more than one

layer of material to a single part (using the same voice, of course),

first record the layers on separate parts, then after ensuring that

there are no mistakes, use the Mix Part job to combine these

separate parts onto a single part.

Please note that if both source part are set to the same part

number, the data from that part will simply be copied to the

destination part.

HINT

Use the

[UNDO][UNDO]

[UNDO] key immediately after executing the Mix Part

function if you accidentally mix the wrong parts or copy them to

the wrong part.