Specifications

76
Appendix
Error Messages
Errors do occur from time to time, and when they do the QY8 will usually
display a message that indicates what type of problem has occurred so you can
rectify it and return to normal operation as quickly as possible.
Battery Err
The battery voltage is too low for proper operation. Replace the old batteries with a set of new
ones. Internal data will be retained while the batteries are replaced.
MemFull Err
The QY8 memory is full or almost full and the specified operation cannot be performed. Delete
unwanted song to make more memory available.
SngDEMO Err
You have attempted to select a different mode during demo song playback. No other mode can
be selected until the other song is selected.
IllInpu Err
This error appears if you attempt to enter a value that is out of range or otherwise unacceptable
in the current situation.
Empty Err
An operation has been specified where no data exists.
DataExi Err
A 1-song bulk dump has been received but the currently selected song already contains data so
the received data was not loaded.
IllData Err
Unrecognizable bulk data has been received by the QY8. Make sure that all bulk data sent to the
QY8 conforms with QY8 MIDI specifications.
BulkIgn Err
Bulk data was transmitted to the QY8 while it was in a mode in which bulk data reception is not
possible. The QY8 can only receive bulk data while the cursor is located at the SONG SELECT
pointer.
BufFull Err
Too much MIDI data is being received by the QY8 at one time. Reduce the amount of data that
is being sent to the QY8.
MidiDat Err
An error has been detected in the MIDI data received by the QY8. Check all relevant settings,
then try receiving the data again.
ChkSum Err
An error has been detected in a MIDI bulk dump received by the QY8. Check all relevant
settings, then try receiving the data again.
TimeOut Err
If a MIDI bulk dump is not completely received, this error message will appear after a short
period of time.