Owner`s manual

48 En
TROUBLESHOOTING
■ USB
Note
If a transmission error occurs but no status message is displayed on the front panel display of the receiver, check the connection between
the DVD player and the USB device (☞p.11).
Power suddenly
shuts off during
playback.
The auto-standby function of the receiver
works when the receiver does not receive
a playing signal transmitted from the
DVD player via the system control cable
for 30 minutes.
Check the connection of the system control cable
between the receiver and the DVD player.
8
No sound or
distorted sound
The sampling rate of a MP3, WMA or
MPEG-4 AAC file may not be
compatible with the DVD player.
Check the sampling rate and bit rate of the MP3,
WMA or MPEG-4 AAC file are compatible with the
DVD player.
3
Disc playback does
not start.
You may use a recordable media that is
not finalized.
Finalize the recordable media.
—
The disc label may not be facing up. Place the disc in the disc tray with the label facing
up.
—
The disc may be defective. Try to play back another disc. If the same problem
does not occur, the disc you want to play back is
defective.
—
MP3/WMA/MPEG-4 AAC disc may not
contain sufficient music tracks to be
played back.
Check that your disc contains at least 5 MP3/WMA/
MPEG-4 AAC music files.
—
The sampling rate of a MP3, WMA or
MPEG-4 AAC file may not be
compatible with the DVD player.
Check the sampling rate and bit rate of an MP3,
WMA or MPEG-4 AAC file are compatible with the
DVD player.
3
The message “HDMI
ERROR” is displayed
or there’s no picture
on the HDMI TV.
The wrong HDMI resolution is selected
or an HDMI error has occurred.
Check the HDMI Resolution setting and correct as
necessary.
41
Reset the HDMI settings.
42
The USB device
cannot be
recognized.
The USB device is not connected
correctly.
Connect the USB device correctly.
11
The DVD player is not
linked with the
receiver.
The system control cable is disconnected
from the system connector jacks of the
receiver and/or the DVD player.
Connect the system control cable properly to the
system connector jacks of the receiver and the DVD
player.
8
Status message Cause Remedy
See
page
NO USB
The USB device is not connected. Connect a playable USB device.
11
OVER CURRENT
The USB device is either unplayable on
this system or connected at an incorrect
angle.
Disconnect the USB device. Change the input source
to a device other than USB and back to USB. Then,
correctly connect a playable USB device to the DVD
player.
—
Problem Cause Remedy
See
page