Owner's Manual

CONTROLS AND FUNCnONs
Remote control
This section describes the function of each button on the
remote control used to control this unit or other
components made by Yamaha or other manufacturers.
I6!ImII indicates buttons that can also be used to control Zone 2.
For more information about Zone
2, see pages 45 and 46.
(1)>-----
~~Tnl---~
II _/XJ£,
~'DIIII
see
6
I\~-::-(I
@
~
/Z>.
~A ~B ~
....--
TV
CD
[IJ IT] (I)
IT]
CD CD
~
1
En"),
[IJ
CD CD
't.Y
~m
@@
~
@- -~I~
~
@YAMAHA
'-
• Common controls
The following buttons can be used no matter which input
source
is selected.
CD Infrared signal transmitter
Sends infrared signals.
8 En
® RECEIVER 0 I6!ImII
Turns this unit on, or sets it to standby mode.
@ 10
Changes the remote controllD (see page 44).
o MAINIZONE 2
Switches the zone to be operated by the remote control
between the Main Zone and Zone 2 (see page 46).
® SLEEP
Sets the sleep timer (see page 19).
® Input selector buttons I6!ImII
Selects the input source and changes the control area (see
page 47).
(j) OPTION
Turns the OPTION menu on and off (see page 40).
® SPEAKERS AlB
Turns on and off the set of speakers connected to the
SPEAKERS A and/or SPEAKERS B terminals on the rear
panel
of this unit when the corresponding button is
pressed.
® MUTE I6!ImII
Mutes the sound output. Press again to restore the sound
output to the previous volume level.
@J VOLUME +/- (16!ImII R-S700 only)
Increases or decreases the sound output level.
Note
This does not affect the output level of the REC jacks.
® RETURN
Returns to the previous menu or ends the menu display
when using the Option menu (see page 40).
@ 1'>. / V' / <J / t> / ENTER
Selects and confirms items in the Option menu (see page
40).
@ CODE SET/RECEIVER
Used to program the remote control so that it can control
your other external components (see page 49).
After using the remote control to control one
of your
components, this button
is used to switch the remote
control to receiver mode so that remote control commands
will be sent to this unit (see page 48).