Manualshelf

Owner's Manual

ManualsBrandsYamaha ManualsHome AudioR-S700
11121314151617181920
CONTROLS ANO FUNCTIONS
Zone
2
remote
control
(R-S700
only)
@VAMAHA
® MUTE
Mutes the sound output to Zone
2.
Press again to restore
the sound output to the previous volume level.
® FM/CATEGORY <J, AM/CATEGORY
I>-
Sets the FM/AM tuner band to FM or AM when TUNER
is
selected as the input source (see page 20).
Selects a channel category when SIRIUS
is
selected
as
the
input source (see page 29).
(j) VOLUME
+/-
Increases or decreases the sound output level
of
Zone
2.
®
PRESET</>
Selects a preset FM/AM station when TUNER
is
selected
as the input source (see page 24).
Selects a preset SIRIUS channel when SIRIUS
is
selected
as the input source (see page 31).
• SIRIUS and FM/AM controls
The following buttons can be used when SIRIUS
or
TUNER
is
selected
as
the input source for Zone
2.
@)
TUN.lCH«
/»
Selects the tuning frequency when TUNER
is
selected
as
the input source (see page 20).
Searches for a SIRIUS channel when SIRIUS
is
selected
as the input source (see page 29).
® Numeric buttons, ENTER
Specifies the frequency or the preset number
of
the FM/
AM station when TUNER
is
selected as the input source
(see page 21).
Specifies the channel number or preset number
of
the
SIRIUS channel when SIRIUS
is
selected
as
the input
source (see page 30).
1---
Insulation sheet
tV
(0
III
10
~
I«PIINJ~
«W'E
~
¢ co )
III
~ ~
((lIffi
(tmJ)
5 ¢1INIl)
«SIU)II~
:'lA£i«T':;
)
III
'aDr
1
~e~
<C~JI'»
This section describes the function
of
each button on the
Zone 2 remote control, which
is
used
to
control Zone
2.
Note
CD------..
The
Zone
2 remote control comes with a battery already installed.
Before using the
Zone
2 remote control for the very first time,
pull out the insulation sheet, as shown.
• Common controls for Zone 2
The following buttons can be used no matter which input
source
is
selected for Zone
2.
• iPod controls
The following buttons can be used when DOCK is
selected as the input source for Zone 2, for listening
to
an
iPhone/iPod. For more information, see page 35.
em
MENU!
t>DD
/1<J<I/1>I>l/ ENTER
CD
Infrared signal transmitter
Sends infrared signals.
® 6 (Zone 2 standby)
Sets Zone 2 to standby mode.
@ I (Zone 2 on)
Turns on Zone
2.
G)
10
Changes the Zone 2 remote control ID (see page 44).
® Zone 2 input selector buttons
Selects the desired input source for Zone
2.
10
En