Owner's Manual
CONNECTIONS
Removing the jumper pins from the PRE OUT/MAIN IN
jacks enables this unit to operate separately as a control
amplifier or a power amplifier. These jacks are used to
connect a signal-processing system such as a graphic
equalizer
or
a surround-sound processor to this unit.
If
an
external unit
is
connected to these jacks, the VOLUME
control
of
this unit can be used to adjust the overall sound
output level.
To
connect an external unit, first remove the jumper pins
from the PRE OUT/MAIN IN jacks and then connect the
input jacks
of
that external unit to the PRE OUT jacks or
its output jacks to the MAIN IN jacks. For details, refer to
the owner's manual included with the external unit to be
connected.
Plug the power cable into the
AC
IN on the rear panel
of
this unit (R-S700 only).
Plug the power cable into the AC wall outlet after all other
connections are complete.
SUB
PCItYER
WOOFER
MANAGEIIEHT
COUPLER
MAIN
IN
® ©
,f-
LOfFON
00
em
® ©
PRE
OUT
•
If
you do not use the COUPLER jacks, never remove the
jumper pins from these jacks.
If
removed, no sound will be
output from this unit.
• Before installing
or
removing the jumper pins, be sure to
disconnect the power cable
of
the unit. Leaving the power cable
connected could cause noise to be emitted from the speakers or
damage the unit.
• When you use this unit as a power amplifier, connect the output
jacks
of
the external control amplifier, etc. to the MAIN
IN
jacks
of
this unit. In this case, the controls
of
this unit will not
function except the PHONES jack and the SPEAKERS
AlB
buttons. Use the controls on the external control amplifier
to
make volume adjustments, etc.
15
En