Owner's Manual

PLAYING AND RECORDING
CAUTION
Extreme caution should be exercised when you play back CDs encoded
in DTS.
If you play back a CD encoded in DTS on a CD player that does not support DTS, only noise will be heard, and this noise
may damage your speakers. Check whether your CD player supports CDs encoded
in DTS. Also, check the sound output
level
of your CD player before you play back a CD encoded in DTS.
SPEAKERS AlB
MAIN ZONE c!.J
INPUT selector
VOLUME
3 Press SPEAKERS A and/or SPEAKERS B on
the front panel or on the remote control to
select speakers A and/or speakers
B.
When speaker set A or speaker set B are turned on,
SP A or SP B
is displayed on the front panel display
accordingly (see page 6).
Note$
• When one set of speakers is connected using bi-wire
connections, or when using two sets
of speakers simultaneously
(A and B), make sure SP A and SP B are displayed
on the front
panel display.
• When listening with headphones,
tum off the speakers.
,.,,~.c,......c,.....~w_ RECEIVER c!.J
Input selector
buttons
SPEAKERS AlB
VOLUME
+/-
1 Press MAIN ZONE 6 on the front panel (or
RECEIVER 6 on the remote control) to turn
on this unit.
2 Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the input source
you want to listen to.
16 En
4 Play the source.
5 Rotate the VOLUME control on the front
panel (or press VOLUME
+/- on the remote
control) to adjust the sound output level.
,"
~<i'~
You can adjust the tonal quality by using the BASS, TREBLE,
BALANCE and LOUDNESS controls, the CD DIRECT AMP
switch (R-S700 only), or the PURE DIRECT switch on the front
panel (see page 17).
6 Press MAIN ZONE 6 on the front panel again
(or RECEIVER 6 on the remote control) to
finish using this unit and set it to standby
mode.