Owner's Manual
CAUTION:
READ
THIS
BEFORE
OPERATING
YOUR
UNIT.
To assure the finest performance, please read this manual
carefully. Keep it in a safe place for future reference.
2 Install this sound system
in
a well ventilated, cool, dry,
clean place - away from direct sunlight, heat sources,
vibration, dust, moisture, and/or cold. For proper
ventilation, allow the following minimum clearances
around this unit.
Top: 30 cm (11-3/4 in)
Rear: 20 cm (7-7/8 in)
Sides: 20 cm (7-7/8 in)
3 Locate this unit away from other electrical appliances,
motors, or transformers to avoid humming sounds.
4 Do not expose this unit to sudden temperature changes
from cold to hot, and do not locate this unit
in
an
environment with high humidity (i.e. a room with a
humidifier) to prevent condensation inside this unit,
which may cause an electrical shock, fire, damage
to
this
unit, and/or personal injury.
5 Avoid installing this unit where foreign object may fall
onto this unit and/or this unit may be exposed to liquid
dripping or splashing. On the top
of
this unit, do not
place:
- Other components, as they may cause damage and/or
discoloration on the surface
of
this unit.
- Burning objects (i.e. candles),
as
they may cause fire,
damage to this unit, and/or personal injury.
- Containers with liquid in them, as they may fall and
liquid may cause electrical shock to the user and/or
damage to this unit.
6 Do not cover this unit with a newspaper, tablecloth,
curtain, etc.
in
order not to obstruct heat radiation.
If
the
temperature inside this unit rises, it may cause fire,
damage to this unit, and/or personal injury.
7 Do not plug
in
this unit to a wall outlet until all
connections are complete.
8 Do not operate this unit upside-down.
It
may overheat,
possibly causing damage.
9 Do not use force on switches, knobs and/or cords.
10
When disconnecting the power cable from the wall outlet,
grasp the plug; do not pull the cable.
11
Do not clean this unit with chemical solvents; this might
damage the finish. Use a clean, dry cloth.
12
Only voltage specified on this unit must be used. Using
this unit with a higher voltage than specified
is
dangerous
and may cause fire, damage to this unit, and/or personal
injury. Yamaha will not be held responsible for any
damage resulting from use
of
this unit with a voltage
other than specified.
13
To prevent damage by lightning, keep the power cable
and outdoor antennas disconnected from a wall outlet or
this unit during a lightning storm.
14
Do not attempt to modify or fix this unit. Contact
qualified Yamaha service personnel when any service
is
needed. The cabinet should never be opened for any
reasons.
15
When not planning to use this unit for long periods
of
time (i.e. vacation), disconnect the
AC
power plug from
the wall outlet.
16
Be sure to read the "TROUBLESHOOTING" section on
common operating errors before concluding that this unit
is
faulty.
iii
En
17
Before moving this unit, press 6 to set this unit to the
standby mode, and disconnect the AC power plug from
the wall outlet.
18
Condensation will form when the surrounding
temperature changes suddenly. Disconnect the power
cable from the outlet, then leave this unit alone.
19
When using this unit for a long time, this unit may
become warm. Turn the power off, then leave this unit
alone for cooling.
20 Install this unit near the AC outlet and where the AC
power plug can be reached easily.
21
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like.
22 Excessive sound pressure from earphones and
headphones can cause hearing loss.
As long as this unit
is
connected to the
AC
wall outlet, it
is
not
disconnected from the AC power source even
if
you set this unit
to
standby mode
by
CJ.
In this state, this unit
is
designed
to
consume a
very small quantity
of
power.
WARNING
TO REDUCE THE RISK
OF
FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
CAUTION
Danger
of
explosion if battery
is
incorrectly replaced.
Replace only with the same or equivalent type.
This label is required to
be
attached to a product
of
which
the temperature
of
the top cover may
be
hot during
operation.