Owner's Manual
ADVANCED
SETUP
• ADVANCED SETUP menu parameters
Change the initial settings to reflect the needs
of
your
listening environment.
,0,
~<i>~
The default settings are marked with
"*".
REMOTE
10
Choices:
IDl,
ID2*
Changes the remote control
ID
of
this unit.
• Select ID I
to
operate this unit using an alternative
code.
• Select ID2
to
operate this unit using the default code.
The remote control's ID (see page 44) must be set to the same
ID
as this unit.
SR PIN (SIRIUS Personal Identification Number)
Choices: CANCEL*, RESET
Resets the Parental Lock code used to lock/unlock
SIRIUS satellite radio channels.
Chal1,f".thilADVANCEQ,sttup
-
metiii,iram,tei'S:.
'."
•
c.
",
,".
';,'
- "",.
'F
.-.
- ,
.•
The ADVANCED SETUP menu is displayed
in
the front
panel display.
,0,
~<i>~
• Audio output is muted while setting parameters
in
the
ADVANCED SETUP menu.
• While setting parameters
in
the ADVANCED SETUP menu,
most controls on the front panel are disabled; only MAIN
ZONE
6,
the INPUT selector and FM MODE/INFO are
operational.
MAIN ZONE(')
FM
MODE/INFO
INPUT selector
APD (Automatic Power Down) TIMER
Choices: 4H (4 hours), 8H*
(8
hours), 12H (12 hours)
When the POWER MANAGEMENT switch on the rear
panel
of
this unit (see page
7)
is
set to ON, this unit's Main
zone and Zone 2 automatically enters standby mode
if
this
unit is not operated for the specified amount
of
time.
When the POWER MANAGEMENT switch
is
set to OFF, "APD
TIMER -OFF" is displayed.
INITIALIZE
Choices: NO*, YES
Resets all parameters to their factory presets.
• Select NO to cancel without resetting all parameters to
their factory presets.
• Select YES to reset all parameters
to
their factory
presets.
Note
If"YES"
is selected the parameters are reset the next time you
tum on the power
of
this unit.
1 Press and hold FM MODEIINFO on the front
panel, and then press MAIN ZONE
c!.J.
This unit turns on, and the ADVANCED SETUP
menu is displayed on the front panel display.
2 Rotate the INPUT selector
on
the front panel
to select the parameter you want to change.
See "ADVANCED SETUP menu parameters"
on
page 43 for a complete list
of
available parameters.
3 Press FM MODE/INFO on the front panel
repeatedly to change the selected parameter
setting.
To
change other settings, repeat steps 2 and
3.
4 Press MAIN ZONE
c!.J
to set this unit to
standby mode to confirm your setting.
Note
The settings you made take effect the next time you tum
on
this
unit.
43 En