Owner's Manual
REMOTE
CONTROL FEATURES
To use this
unit's
remote
control to control
other
components
(TV,
DVD
player,
VCR,
etc.),
determine
the
remote
control
code
that
corresponds
to the
component
and
assign
that
code
to the
desired
input
selector
button
on
the
remote
control.
Remote
control codes
are
listed in the
"LIST
OF
REMOTE
CONTROL
CODES"
at the
end
of
this
manual.
•
Assigning
remote control codes
1 Refer
to
the "LIST
OF
REMOTE CONTROL
CODES" at the end
of
this
manual and
determine the remote control code that
corresponds
to
each
of
your
components.
Components
are listed
by
category
(TV,
VCR,
DVD
player, etc.) and manufacturer.
• Default remote control configuration
The
remote
control
is
configured
at
the factory
as
shown
below.
4 Use the numeric buttons on the remote
control
to
enter the four-digit remote control
code corresponding
to
the component you
want
to
assign.
When
the
component
has
been
assigned,
"OK"
is
displayed
on
the
front panel display.
If
an
error
occurs,
"NG"
is displayed.
2 Press and hold CODE SET on the remote
control for more than 3 seconds.
3 Press an input selector button on the remote
control
to
select the
input
source you want
to
configure.
You
can
also press
TV
C)
to
configure
the
TV
control
buttons (see
page
47).
• If
the
manufacturer of your component has more than one
remote control code, assign each code one
at
a time until
you
find
the
code that successfully controls your component.
•
You
can only assign one remote control code
to
each input
selector button.
• Resetting the remote control
Use
this
procedure
to
reset
the
remote
control
codes
assigned
to
each
input
selector
to
the
factory
default
(see
"Default
remote
control
configuration"
above).
5082
5087
TVc!:J
Yamaha
Yamaha
Numeric
.
~.:..,-;-,.;--
buttons
,;-+...,.-...,.-...,.-;:-:-:;-';'-
CODE SET
TAPE deck
CD playerCD
TAPE
OPTION
Input selector
buttons
PHONO
Note
LINEl
LINE 2
CD recorder
DVD player
Yamaha
Yamaha
5083
2082
This procedure will
be
cancelled if
you
do
not press any buttons
for
I minute.
If
the procedure
is
cancelled, repeat
from
step I
if
necessary.
LINE
3
Blu-ray disc
player
Yamaha
2064
1 Press and hold CODE SET on the remote
control for more than 3 seconds.
TVc!:J
2 Press OPTION on the remote control.
Note
If
you
cannot operate a Yamaha component when the remote
control
is
configured using the remote control code listed above,
refer
to
the "LIST OF REMOTE CONTROL CODES" at the end
of manual and
try
assigning a different Yamaha remote control
code.
3 Use the numeric buttons on the remote
control
to
enter "9981".
The
remote
control
code
assigned
to
each
input
selector
button
will
be
reset to its factory default
code.
49 En