User Manual

13
Let’s place a slider that controls the volume.
1. In the menu bar, tap the Page Edit button .
2. In the widget menu, tap the slider icon and then move
it where you like.
3. The device that will be controlled is the same as the
one you specified for the button, so there’s no need to
specify it again.
Of course you are also free to specify a different device.
4. Tap the slider, and tap [Parameter] in the context
menu.
The [Slider Parameter Assign] screen appears.
5. In the [Devices] list, tap the “device” that you speci-
fied in step 1 of “2. Specify devices and parameters.”
A list of the assignable parameters appears.
Select the volume parameter that you want to control using this slider.
For example if you want the slider to adjust the channel 1 input level,
make the setting shown in the screen below.
* For more about [Upper], [Lower], [Home Position],and [Tooltip], refer to
“Assigning parameters.”
6. Tap [Done] to complete the assignment.
Move to control mode, and operate the slider to check it.
You can also change the design of the slider as you did for the but-
ton. For details, refer to “Widget design.”
4. Place a slider