User Manual

13.9.3. Controlling a Snapshot and ParamSet in the control component
You can control a snapshot and parameter set in the control component.
For more information on the parameter set and snapshot, refer to the “’Parameter Sets’ area” section.
■ An example of control using the Snapshot component
1. Drag and drop Snapshot from “Snapshot” in the “Parameter Set” area to the Control layer. The Snapshot
component appears in the Control layer.
2. Snapshot is recalled when a signal is input to the input port.
3. When the snapshot is recalled, “1” is output from the output port.
■ An example of control using the ParamSet component
You can also control a snapshot using the ParamSet component. In this section, two control examples are
introduced: using Snaspshot pins, and using a Sel pin.
[1] An example of control using Snapshot pins
1. Drag and drop the Parameter Set in the “Parameter Sets” area to the Control layer. The Param.Set
component that includes multiple Snapshot components appears in the Control layer.
2. Select Parameter Set in the “Parameters” area, and then click the “+” mark next to “Snapshot” to expand
the snapshot list.
13. Audio Processors : DME7
ProVisionaire Design User Guide | 129