User Manual

13.14.3. Component editor / Parameter setting window
When you right-click a component editor or a parameter setting window, the following context menu appears.
Menu Content
[Register as default values] Register the component’s current parameter values in a style as the
default values. New components will be placed with the registered default
values.
The registered default values can be imported/exported as a style file.
[Reset default values to Factory
Default]
Returns the default value of the component to the values immediately
after ProVisionaire Design was installed.
[Copy] Copies the component, including the parameter settings of the
component editor.
[Paste Parameters] Content If you select an existing component of the same type and
execute this, the copied parameters of the component are applied.
[Add to Parameter Set] If you execute this on a parameter, the parameter is registered in the
parameter set.
If you execute this elsewhere than on a parameter, the component is
registered in the parameter set.
[Add to Remote Control List] If you execute this on a parameter, the parameter is registered in the
Remote Control Setup List.
If you execute this elsewhere than on a parameter, all of the component’s
parameters or the component’s meters are registered in the Remote
Control Setup List.
13.14.4. Wire
Right-click an item to open the subsequent context menu.
Menu Content
[Delete] Deletes the wire.
[Bring to Front] Moves the selected wire to the front.
[Send to Back] Moves the selected wire to the back.
[Add to Transmitter ＆ Receiver
Space]
Connect wires to the Transmitter and Receiver components.
[Insert Node] Add nodes to the wire. * A node is a dividing point of a wire.
[Remove Segment] Removes wires between nodes.
13. Audio Processors : DME7
ProVisionaire Design User Guide | 145