User Manual

14.9.1. "Analog In" component editor
Here you can make settings to the HA (head amp) of the [INPUT] jack, and view the levels of the audio signals
that are being input.
① Channel index
Indicates the analog input jack number.
② Level meter
Indicates the analog input level.
③ [GAIN] knob
Adjusts the analog gain of the HA (head amp).
④ [+48V] button
Turns the HA phantom power (+48V) on/off.
Notice
Be sure to leave this button off if you do not need phantom power.
When turning phantom power on, you must observe the precautions below in order to prevent noise and
possible damage to the unit and to external devices.
• Leave this button off if a device that does not support phantom power is connected to the [INPUT]
connector.
• Do not connect/disconnect a cable to/from the [INPUT] connector while this button is on.
• Lower the output level to the minimum before turning phantom power on/off.
There is no +48V Active switch. To avoid malfunctions, be sure to set this appropriately for the equipment
that is connected.
14. Audio Processors : MTX5-D/MTX3
ProVisionaire Design User Guide | 215