User Manual

17.2.1. "Properties" area
"Input Source ＆ Redundancy"
Here you can specify for each channel whether the input source to the XMV will be digital or analog. If the input
source is specified as digital, you can specify that the input source will switch from digital to analog when a pilot
tone or analog input is detected. Here we explain the screen for when the digital input is Dante.
When you click on the Value field for each channel in the Properties Area "Input Source＆Redundancy," and then
click the "…" that is displayed, the "Input Source & Redundancy" dialog will be displayed.
•
[Redundant Mode] list box
Selects the redundancy method.
◦ [Off]
Redundancy is disabled.
◦ [Backup]
Switch to analog input when the pilot tone of the digital input is interrupted due to a broken
connection or other problem.
◦ [Override]
Switch to the analog input when analog audio is detected.
•
[Auto Return] check box
If this check box is selected, operation will be as follows.
◦ In the case of Backup mode
When the digital input recovers, the input source is switched from analog to digital.
◦ In the case of Override mode
When the analog input falls below the threshold value, the input source is returned from analog to
digital.
•
Channel index
Shows the input channel number for which to make settings.
•
"Primary Input Source" area
Here you can specify for each channel whether the input will be digital or analog.
◦ [YDIF (Digital)]/[Dante (Digital)] option button
The signal of the corresponding channel is taken from YDIF or Dante.
17. Power Amplifiers : XMV-series
272 | ProVisionaire Design User Guide