User Manual

that might occur if the volume of the background music were raised during a noisy time.
If the check box is selected, the Nominal function will be on.
[Nominal Value] specifies the nominal value.
[Nominal LED Position] specifies the LED position that will light when the level reaches the nominal value.
•
[Sensitivity]
Sets the sensitivity of parameter changes in response to the rotary operation of the DCP knob.
If [Acceleration] is on, the parameter will change faster if the knob is rotated more rapidly. If [Fast] is
selected as the [Sensitivity], the [Acceleration] setting is dimmed and unavailable.
● [Dimmer & Lock] tab
Specifies the brightness of the DCP unit’s LEDs. Higher values will make the LEDs brighter.
•
[LED Brightness] list box
Specifies the brightness of the DCP unit’s LEDs. Higher values will make the LEDs brighter.
◦ [Enable Inactive Mode] check box
If the check box is selected, the unit automatically enters inactive mode after a time duration
specified in [Waiting Time].
[Inactive LED Brightness] specifies the brightness of the LEDs when inactive.
If the check box is cleared, the drop-down menu is grayed-out and you will be unable to set the
brightness.
•
[Panel Lock] check box
If this check box is selected, the DCP panel will be locked when the snapshot library is recalled.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding down DCP switch 1 for
two seconds will unlock the panel.
•
[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the panel is locked.
26. DCP
ProVisionaire Design User Guide | 331