User Manual

The wiring diagram and the Clock Source will be displayed.
Follow the displayed wiring diagram to connect the actual devices to each other with YDIF cables.
Note that there are two patterns: one in which ring connection is not required (left diagram), and the other in
which ring connection is required (right diagram).
When you press the [Finish] button, a YDIF-connected device group will be created in the Project sheet.
The wizard-based setup has the following two advantages.
(1) Selecting the wrong combination of devices will prevent the wizard from completing, allowing you to check
for misconnections in advance.
(2) Ring connection decisions are also performed automatically.
Similar setting are also possible by wiring YDIF connectors between devices without using the wizard.
Note that in this case, there will be no warnings about mistaken connections that the wizard provides. In such
cases, a ring connection is recommended as usual.
27. YDIF
ProVisionaire Design User Guide | 343