User Manual

Yamaha Commercial Audio
Dante-MY16-AUD HA Remote Control Guide
3 www.yamahaproaudio.com
System Examples
LS9 system example
When inserting the Dante-MY16-AUD card into your LS9, you can remote-
control the HA of an I/O rack on the Dante network from the LS9, with just a
simple network connection. From the LS9, each Rio1608-D is recognized and
controlled as two units of AD8HR (one unit for the Ri8-D). Please ensure that
the card bridging an HA control signal is always inserted into slot 1 (for the
LS9-32).
PM5D system example
To remote-control the HA of an I/O rack on the Dante network from the PM5D,
you need to connect the REMOTE terminals between the console and the
card with a serial cable (straight, female–male), in addition to the network
connection.
In a redundantly connected Dante network, the control signal as well as the
audio signal, passes through both circuits. Therefore, even if the primary
circuit is broken, the communication of HA control can continue by using the
secondary circuit.
Slot 1: mode 2
mode 2
LS9
-16
LS9-32
Rio1608-D
Rio1608-D
Ri8-D
Ri8-D
mode 3
Rio1608-D
Rio3224-D
Primary
Secondary
PM5D/PM5D
-RH