User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-70-
Preset Elements
Use the Preset Elements column to select the parameters that you wish to apply from the preset to the
target network.
If the target network is not identical to the original network (from which the preset was saved), some
elements might not be applied successfully. For example, if some devices on the target network do not
support the same range of sample rates as the devices on the original network, you could choose not to
apply the 'Device Sample Rate' element, and change the sample rates manually instead, once the preset
has been applied.
Preset Roles
The Preset Roles column lists the roles that were saved in the preset.