User Manual

27
Let’s operate the widgets on each page to verify that they work. We
assume that there is a device that is being controlled.
1. Power-on the device.
2. Connect the computer to the network that is con-
nected to the device’s NETWORK port.
For details on settings for the computer, refer to “Specifying the IP
address.”
3. On the title bar, click the [Setup] button .
The “Setup” dialog box opens.
4. Select the network interface card that is connected to
the network that is connected to the device’s NET-
WORK port.
5. Click the [OK] button.
The dialog box closes.
6. In the “Controllers” area, select the controller that you
want to operate.
7. On the tool bar, click the [Run] button .
KIOSK starts.
NOTE
An instance of KIOSK that is started by clicking the [Run] button dif-
fers from a stand-alone instance of KIOSK; for example, it has no
[Setup] button.
8. Note that the indication “All Devices are ONLINE” is
shown in the upper right.
If this indicates “All Devices are OFFLINE,” then KIOSK has not
detected the devices. Make sure that the network settings of the
devices and the computer are correct.
9. Click the button labeled “CL5.”
The page changes.
10. Operate the fader and button, and verify that they
are linked with the device.
If you want to edit the placement etc., exit KIOSK and proceed as
described in “Adjusting the placement of the widgets.” The
changes are not applied if KIOSK is left running.
11. Exit KIOSK.
Testing operation