User Manual

Table Of Contents

CL Editor Owner’s Manual

C PAN/ST/M(C)

The PAN knob adjusts the panning of the signal that is sent from the INPUT CH to the

STEREO bus L/R channels (or the L/C/R channels.) You can set this to the center value by

holding down the <Ctrl>(< >) key of your computer keyboard and clicking this knob.

The [ST] button is an on/off switch for the signal that is sent from the INPUT CH to the

STEREO bus. The [M(C)] button is an on/off switch for the signal that is sent from the

INPUT CH to the MONO bus.

If LCR MODE is selected in the Selected Channel window, the [LCR] button will appear

instead of the [ST] button and [M(C)] button, and the [LCR] button will be an on/off switch

for the signal that is sent from the INPUT CH to the LCR bus.

D SEL (Channel selection)

Selects the INPUT CH for which you want to perform operations.

E CUE

This button cue-monitors the signal of the INPUT CH.

In the ONLINE state, if MATRIX bus channels 7 and 8 can be used as a second cue, the

indication shows “CUE A,” “CUE B,” or “CUE AB” depending on the settings of the

console.

If the Channel Select/Sends On Fader checkbox in the System Setup dia-

log box is not checked, the [CUE] button will be hidden in the screen.

F ON

Switches the INPUT CH or send on/off.

The button is color-coded and indicates status as follows:

White: INPUT CH is on (normal mode.)

Black: INPUT CH/Send are off.

Other colors: Send is on (SENDS ON FADER mode.)

G Fader

Adjusts the input level of the INPUT CH, or the send level.

The fader is color-coded and indicates status as follows:

White: You can adjust the input level of the INPUT CH (normal mode.)

Gray: INPUT CH is off.

Other colors: You can adjust the send level (SENDS ON FADER mode.)

The current fader value is shown in the numerical box located immediately below the fader.

You can set this to the minimum value (–∞ dB) by holding down the <Ctrl>(< >) key of

your computer keyboard and clicking the fader knob, or set it to the nominal value

(0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key and clicking the fader

knob.

The numbers and alphabetical letters at the right of the fader indicate the DCA group and

mute groups to which that channel belongs, and show the Recall Safe and Mute Safe status

of the channel.

In Surround mode (➥ p.3), the Send indication for MIX buses 1-6 will

be switched to the surround panning and LFE level indication. Double-

click any part of the Surround Mode indicator to open the Selected

Channel window for the corresponding channel.

Surround Mode indicator

NOTE